Free Cisco 300-510 Exam Dumps and 300-510 Exam Questions

Question No: 1

MultipleChoice

Refer to the exhibit.

A customer reports that Host-1 is failing to receive streaming traffic from the IPTV source. The engineer has confirmed that hosts on router R2 are receiving traffic normally and that Host-1 is correctly sending subscription messages to join the IPTV stream. Which action must the engineer take to correct the problem?

Options

AConfigure IP PIM SSM and IGMP version 2 under interface GigatxtEthernet 1/0/1 on R3

BConfigure IGMP version 3 under interface GigabitEthernet 1/(V1 on R3

CRemove IP PIM SSM and IGMP from interface GigaEthernet 1/0/1 on R3 and configure under global configuration

DRemove IP PIM SSM from the global configuration on R3 and configure it under the GigabitEthernet 1/0/1 interface

Question No: 2

MultipleChoice

Refer to the exhibit.

An administrator is troubleshooting Internet access issues on a customer's network. After applying this ISIS configuration to R1, the administrator notices that it fails to redistribute the default route into IS-IS. After checking the connectivity between the ISIS router and the ISP router the engineer confirmed there is Layer 3 connectivity between them Which action should be taken to correct the problem?

Options

AAssociate the default route with a VRF

BAdd the default-information originate command to the configuration

CConfigure the default route under any routing protocol other than IS-IS

DConfigure R1 as a Layer 1 router

Question No: 3

MultipleChoice

Refer io the exhibit.

While applying the configurations on two routers an engineer notices that OSPF adjacency Between them remains down Through the ping test the engineer confirmed that both me routers have Layer 3 reachability between them Which action should me engineer take to make the adjacencies to full?

Options

AEnter the command ip ospf authentication in R2 interface

BEnable OSPF just inside the router OSPF process not in the interfaces of any router

CDelete the area 0 authentication message-digest command from the OSPF process in R1

DDelete the area 0 authentication message-digest command from the OSPF process in R2

Question No: 4

MultipleChoice

Refer to the exhibit.

Why is neighbor 10.1.5.5 stuck in ''2WAY'' state?

Options

ARouter ID 10.1.5.5 is not reachable from R2

BOSPF authentication has failed between R2 and 10.1.5.5

CIt is an expected behavior when OSPF network type is broadcast

DOSPF parameters (Area ID or hello interval) are mismatched between R2 and 10.1.5.5