Free Cisco 350-401 Exam Dumps and 350-401 Exam Questions

Question No: 21

MultipleChoice

Configure OSPF on both routers according to the topology to achieve these goals:

Options

AExplanation:
Solution:
R1
Router ospf 1
Int loop0
Ip ospf 1 area 0
Int et0/0
Ip ospf 1 area 0
Ip ospf network point-to-point
Copy run start
R2
Router ospf 1
Int loop0
Ip ospf 1 area 0
Int et0/0
Ip ospf 1 area 0
Ip ospf network point-to-point
Copy run start
Verification:-

Question No: 22

MultipleChoice

Refer to the exhibit.

Communication between London and New York is down. Which command set must be applied to the NewYork switch to resolve the issue?

A)

B)

C)

D)

Options

AOption A

BOption B

COption C

DOption D

Question No: 23

MultipleChoice

Refer to the exhibit.

After configurating an IPsec VPN, an engineer enters the show command to verify the ISAKMP SA status. What does the status show?

Options

AISAKMP SA is authenticated and can be used for Quick Mode.

BPeers have exchanged keys, but ISAKMP SA remains unauthenticated.

CVPN peers agreed on parameters for the ISAKMP SA

DISAKMP SA has been created, but it has not continued to form.

Question No: 24

MultipleChoice

Refer to the exhibit.

--Image Miss--

An engineer must create a configuration that prevents R3from receiving the LSA about 172.16.1.4/32.Which configuration set achieves this goal?

A)

B)

C)

Options

AOption A

BOption B

COption C

DOption D

Question No: 25

MultipleChoice

Which command must be applied to R2 for an OSPF neighborship to form?

Options

Anetwork 20.1.1.2.0.0.0.0 area 0

Bnetwork 20.1.1.2 255.255.0.0. area 0

Cnetwork 20.1.1.2.0.0.255.255 area 0

Dnetwork 20.1.1.2 255.255.255 area 0

Question No: 26

MultipleChoice

What does the cisco REST response indicate?

Options

ACisco DNA Center has the Incorrect credentials for cat3850-1

BCisco DNA Center is unable to communicate with cat9000-1

CCisco DNA Center has the incorrect credentials for cat9000-1

DCisco DNA Center has the Incorrect credentials for RouterASR-1

Question No: 27

MultipleChoice

A network engineer configures a new GRE tunnel and enters the show run command. What does the output verify?

Options

AThe tunnel will be established and work as expected

BThe tunnel destination will be known via the tunnel interface

CThe tunnel keepalive is configured incorrectly because they must match on both sites

DThe default MTU of the tunnel interface is 1500 byte.

Question No: 28

MultipleChoice

Refer to the exhibit

Communication between London and New York is down Which command set must be applied to resolve this issue?

A)

B)

C)

D)

Options

AOption A

BOption B

COption C

DOption D

Question No: 29

MultipleChoice

Refer to the exhibit.

An engineer must block all traffic from a router to its directly connected subnet 209.165.200.0/24. The engineer applies access control list EGRESS in the outbound direction on the GigabitEthernet0/0 interface of the router However, the router can still ping hosts on the 209.165.200.0/24 subnet. Which explanation of this behavior is true?

Options

AAccess control lists that are applied outbound to a router interface do not affect traffic that is sourced from the router.

BOnly standard access control lists can block traffic from a source IP address.

CAfter an access control list is applied to an interface, that interface must be shut and no shut for the access control list to take effect.

DThe access control list must contain an explicit deny to block traffic from the router.

Question No: 30

MultipleChoice

Refer to the exhibit.

An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP legs in. Which configuration change is required''

Options

AAdd the access-class keyword to the username command

BAdd the access-class keyword to the aaa authentication command

CAdd the autocommand keyword to the username command

DAdd the autocommand keyword to the aaa authentication command