Free Cisco 350-801 Exam Dumps and 350-801 Exam Questions

Question No: 1

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. What is the registration state of the analog port in this debug output?

Options

AThe analog port failed to register to Cisco UCM with an error code 200.

BThe MGCP Gateway is not communicating with the Cisco UCM.

CThe analog port is currently shut down.

DThe analog port is registered to Cisco UCM.

Question No: 2

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. An administrator accesses the terminal of a Cisco UCM and starts a packet capture. Which two commands must the administrator use on Cisco UCM to generate DNS traffic? (Choose two.)

Options

Autils ntp status

Bshow cdp neighbor

Cshow version active

Dutils diagnose test

Eautils diagnose module validate Network

Question No: 3

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?

Options

AThe call fails because device mobility is turned on, and the phone is not configured in New York. The engineer must configure which sites the device should be roaming to.

BThe call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco.

CThe call fails because the Standard Local Route Group is being used only it no configuration is set for the device pools.

DThe call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway.

Question No: 4

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A collaboration engineer is configuring the Cisco UCM IM and Presence Service. Which two steps complete the configuration of the SIP trunk security profile? (Choose two.)

Options

ACheck the box to enable application-level authorization.

BCheck the box to allow charging header.

CCheck the box to accept unsolicited notification.

DCheck the box to transmit security status.

ECheck the box to accept replaces header.

Question No: 5

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. When making a call to a Mobile and Remote Access client, what are the combinations of protocol on each of the different sections A-B-C?

Options

AIP TCP/TLS (A) + SIP TCP/TLS (B) + SIP TLS (C)

BSIP TCP/TLS (A) + SIP TCP/TLS (B) + SIP TCP/TLS (C)

CSIP TLS (A) + SIP TLS (B) + SIP TLS (C)

DSIP TCP/TLS (A) + SIP TLS (B) + SIP TLS (C)

Question No: 6

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. When a UC Administrator is troubleshooting DTMF negotiated by this SIP INVITE, which two messages are examined next to further troubleshoot the issue? (Choose two.)

Options

AREGISTER

BSUBSCRIBE

CPRACK

DNOTIFY

EUPDATE

Question No: 7

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A collaboration engineer configures Cisco UCM to act as a DHCP server. What must be done next to configure the DHCP server?

Options

ARestart the Cisco DHCP Monitor Service under Cisco Unified Serviceability

BAdd the new DHCP server to the primary DNS server

CRestart the TFTP service under Cisco Unified Serviceability.

DAdd a DHCP subnet to the DHCP server under Cisco UCM Administration.

Question No: 8

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. A customer submits this debug output, captured on a Cisco IOS router. Assuming that an MGCP gateway is configured with an ISDN BRI interface, which BRI changes resolve the issue?

A.

B.

C.

D.

Options

AOption A

BOption B

COption C

DOption D

Question No: 9

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. Endpoint A calls endpoint B. What is the only audio codec that is used for the call?

Options

AG722/8000

BTelephone-event/8000

CG7221/16000

DPCMA/8000

Question No: 10

MultipleChoice

Refer to the exhibit.

Refer to the exhibit. Calls to Cisco Unity Connection are failing across Cisco Unified Border Element when callers try to select a menu prompt Why is this happening and how is it fixed?

Options

ACisco Unity Connection is configured on G.729 only. Cisco Unity Connection must be reconfigured to support iLBC.

BCisco Unified Border Element is not sending any support for DTMF. OTMF configuration must be added to the appropriate dial peer.

CCisco Unified Border Element is sending the incorrect media IP address. The IP address of the loopback interface must be advertised in the SDP

DThe Cisco Unity Connection Call Handler is configured for a 'Release to Switch' transfer type Transfers must be disabled for the Cisco Unity Connection Call Handler