Cisco Exam 200-301 Topic 20 Question 59 Discussion

Actual exam question for Cisco's 200-301 exam

Question #: 59
Topic #: 20

Configure IPv4 and IPv6 connectivity between two routers. For IPv4, use a /28 network from the 192.168.1.0/24 private range. For IPv6, use the first /64 subnet from the 2001:0db8:aaaa::/48 subnet.

1. Using Ethernet0/1 on routers R1 and R2, configure the next usable/28 from the 192.168.1.0/24 range. The network 192.168.1.0/28 is unavailable.

2. For the IPv4 /28 subnet, router R1 must be configured with the first usable host address.

3. For the IPv4 /28 subnet, router R2 must be configured with the last usable host address.

4. For the IPv6 /64 subnet, configure the routers with the IP addressing provided from the topology.

5. A ping must work between the routers on the IPv4 and IPv6 address ranges.

AExplanation:
Answer as below configuration:
on R1
config terminal
ipv6 unicast-routing
inter eth0/1
ip addre 192.168.1.1 255.255.255.240
ipv6 addre 2001:db8:aaaa::1/64
not shut
end
copy running start
on R2
config terminal
ipv6 unicast-routing
inter eth0/1
ip address 192.168.1.14 255.255.255.240
ipv6 address 2001:db8:aaaa::2/64
not shut
end
copy running start
---------------------
for test from R1
ping ipv6 2001:db8:aaaa::1
for test from R2
ping ipv6 2001:db8:aaaa::2

Show Suggested Answer

Suggested Answer: A

by Antione at Nov 19, 2022, 10:48 PM

Limited Time Offer

25%

Off

Get Premium 200-301 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!