Cisco Exam 200-301 Topic 3 Question 60 Discussion

Actual exam question for Cisco's 200-301 exam

Question #: 60
Topic #: 3

Physical connectivity is implemented between the two Layer 2 switches, and the network connectivity between them must be configured

1. Configure an LACP EtherChannel and number it as 1; configure it between switches SW1 and SVV2 using interfaces Ethernet0/0 and Ethernet0/1 on both sides. The LACP mode must match on both ends

2 Configure the EtherChannel as a trunk link.

3. Configure the trunk link with 802.1 q tags.

4. Configure the native VLAN of the EtherChannel as VLAN 15.

AExplanation:
Answer as below configuration:
On SW1:
conf terminal
vlan 15
exit
interface range eth0/0 - 1
channel-group 1 mode active
exit
interface port-channel 1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 15
end
copy run start
on SW2:
conf terminal
vlan 15
exit
interface range eth0/0 - 1
channel-group 1 mode active
exit
interface port-channel 1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 15
end
copy run start

Show Suggested Answer

Suggested Answer: A

by Raina at Dec 10, 2022, 09:51 AM

Limited Time Offer

25%

Off

Get Premium 200-301 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!