Simulation 3
TASK1:
Run ''sh run'' command on both routers, check if there is any ''router ospf'' configured. If it's configured, check if Loopback0 ip it's being used as OSPF ID. If it's, jump to TASK2. Otherwise run:
R1
router ospf 10
router-id 10.1.1.1
R2
router ospf 10
router-id 10.2.2.2
TASK2:
R1 & R2
int lo0
ip ospf 10 area 0
ip ospf network point-to-point
!
int e0/0
ip ospf network point-to-point
ip ospf 10 area 0
ip ospf authentication message-digest
ip ospf message-digest-key 1 md5 C1sc0!
!
Gayla
2 months agoLuann
2 months agoKris
1 months agoMollie
2 months agoGlendora
2 months agoElenore
2 months agoDominga
1 months agoJules
1 months agoTommy
2 months agoLeana
2 months agoAzzie
2 months agoLindsey
2 months agoAzzie
3 months agoMari
3 months agoMing
2 months agoBroderick
2 months agoRolland
2 months agoGalen
2 months ago