Cyber Monday 2024! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Cisco Exam 350-601 Topic 10 Question 60 Discussion

Actual exam question for Cisco's 350-601 exam
Question #: 60
Topic #: 10
[All 350-601 Questions]

Refer to the exhibit.

Refer to the exhibit. A traffic collector virtual machines is installed inside the cisco ucs server. The collector must monitor traffic that is received on G1/2 with ERSPAN Which set of actions must be taken to send the traffic to the traffic collector?

Show Suggested Answer Hide Answer
Suggested Answer: A

Contribute your Thoughts:

Dusti
8 months ago
ERSPAN, the secret handshake of the networking world. I bet they're going to try to trick us with this one. We'll need to pay close attention to the details.
upvoted 0 times
...
Britt
8 months ago
Ah, ERSPAN, the bane of every network engineer's existence! But I think I know the answer to this one. Let's see what the options are and see if we can figure it out.
upvoted 0 times
...
Fernanda
8 months ago
Hmm, this looks like a tricky one. ERSPAN can be a bit finicky, and I remember having issues with it in the lab. We'll need to make sure we understand the correct configuration to get the traffic from G1/2 forwarded to the collector.
upvoted 0 times
Dexter
8 months ago
Test the traffic flow to verify that the setup is working as expected.
upvoted 0 times
...
Francesco
8 months ago
Ensure that the ERSPAN session is active and properly capturing the traffic.
upvoted 0 times
...
Ettie
8 months ago
Check the configuration for any errors or missteps.
upvoted 0 times
...
Salena
8 months ago
Confirm that the traffic from G1/2 is being correctly forwarded to the traffic collector.
upvoted 0 times
...
Orville
8 months ago
Make sure the ERSPAN session is set to monitor the source VLAN.
upvoted 0 times
...
Dewitt
8 months ago
Set up an ERSPAN session with the destination IP address of the traffic collector.
upvoted 0 times
...
Chaya
8 months ago
Configure the source VLAN to G1/2.
upvoted 0 times
...
...
Desire
8 months ago
This question seems straightforward, but I'm not entirely sure about the answer. The exhibit shows a Cisco UCS server, and the question is asking about configuring ERSPAN to send traffic from a specific interface to a traffic collector VM. I'll have to carefully review the options and think through the steps required.
upvoted 0 times
...

Save Cancel
az-700  pass4success  az-104  200-301  200-201  cissp  350-401  350-201  350-501  350-601  350-801  350-901  az-720  az-305  pl-300  

Warning: Cannot modify header information - headers already sent by (output started at /pass.php:70) in /pass.php on line 77