Free Preparation Discussions
MENU
Dell EMC DES-5121 Exam Questions
- Dell EMC Dell Networking Certifications
- Dell EMC Implementation Engineer Certifications
- Dell EMC Implementation Engineer Campus Networking Specialist Certifications
- Topic 1: Compare and contrast the various port security methods and identify ports with port security enabled/ Identify and the describe the steps to upgrade switch firmware
- Topic 2: Describe VRRP priorities including contrast and compare preemption versus no preemption/ Identify and describe the common Campus networking topologies
- Topic 3: Explain how to determine a port VLAN membership and configure port trunking/ Explain the typical end-to-end data flow of a Campus network
- Topic 4: Identify and describe the configuration requirements to support VoIP devices/ Explain how to configure and validate policy-based routing (PBR) configurations
- Topic 5: Identify and describe VRRP components and their basic operations/ Describe how to configure QoS on Dell EMC N-Series switches
- Topic 6: Describe how RSTP, MSTP, and RSTP-PV are configured and validated/ Identify and describe the various commands used to either deny or permit IP connectivity
- Topic 7: Describe how to configure PortFast, FastLink, and STP protection/ Explain how to configure a Dell EMC N-Series switch including boot sequence
- Topic 8: Describe the differences between the initial setup requirements for a standalone switch versus a stack of switches/ Explain how to troubleshoot LAG configuration mismatches
- Topic 9: Describe the purpose of AAA security; configure local authentication and AAA security/ Describe policy-based routing (PBR) basic operations
- Topic 10: Describe how to configure PoE on a switch port and measure power output/ Identify and describe the steps required to configure multicasting into an existing multicast environment
Free Dell EMC DES-5121 Exam Actual Questions
Note: Premium Questions for DES-5121 were last updated On 28-05-2024 (see below)
What is a recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?
N4032F#show interfaces status
N4032F#show interfaces port-channel 1
Hash Algorithm Type
1 - Source MAC, VLAN, EtherType, source module and port Id
2 - Destination MAC, VLAN, EtherType, source module and port Id
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port
5 - Source/Destination MAC, VLAN, EtherType, source MODID/port
6 - Source/Destination IP and source/destination TCP/UDP port
7 - Enhanced hashing mode
N4032F#
A Dell EMC N-Series switch has been configured with a 2-member port-channel; however, only one link is currently active.
Based on the exhibit, why is only one link active?
If VoIP traffic uses multiple QoS prioritization schemes, what refers to VoIP traffic?
In order to alter a packet's routing direction, which packet layers can policy-based routing use?
- Select Question Types you want
- Set your Desired Pass Percentage
- Allocate Time (Hours : Minutes)
- Create Multiple Practice tests with Limited Questions
- Customer Support
Currently there are no comments in this discussion, be the first to comment!