Free Preparation Discussions
MENU
HP0-Y47 Exam Questions
- Topic 1: Describe network management and monitoring protocols
- Topic 2: How technologies such as sFlow NetFlow NetStream and RMON are used to monitor network traffic
- Topic 3: Describe the HPE Flex Network products solutions and service offering
Free HP HP0-Y47 Exam Actual Questions
Note: Premium Questions for HP0-Y47 were last updated On 17-10-2016 (see below)
A company has a network with HP Provision switches. The network administrator is establishing remote mirroring session between two of the switches. The remote does not use the truncation option.
What must the administrator check on any switches between the mirror source and destination?
Details
For remote traffic mirroring, enable jumbo frames to mirror Ethernet frames larger than 1464 bytes.
On both source and destination switches and any infrastructure switches in between Mirrored frames sent to remote switch include an additional 54-byte mirror encapsulation header
5406zl(config)#vlan 10 jumbo Source switch
5412zl(config)#vlan 10 jumbo Intermediate switch
3500yl(config)#vlan 10 jumb0 Destination switch
When the source switch sends the mirrored data stream to the destination switch, it adds a 54-byte proprietary ('mirror encapsulation') header to the Layer 2 frame, increasing the total size of the frame.
http://h20565.www2.hp.com/hpsc/doc/public/display?sp4ts.oid=82374&docId=emr_na-c02587751&docLocale=en_US
Refer to the exhibit.
Exhibit 1
Exhibit 2
Client 1 is transmitting traffic to the data center. Switch 3 transmits the traffic on the link to Switch 1. How does Switch 1 handle the traffic received from Client 1?
From the exhibit we see that destination MAC address is accessible.
Refer to the exhibit.
.
A network administrator has begun configuring a Protocol Independent Multicast Sparse Mode (PIM-SM) solution on all of the network infrastructure devices shown in the exhibit. The administrator has selected the static method for configuring rendezvous (RPs) and wants to use 4 as RP.
Where must the administrator configure the static RP setting?
In Static-RP configuration, you need to configure ''ip pim rp-address x.x.x.x'' command on every multicast enable router in your network including RP itself.
http://mrncciew.com/2013/01/19/pim-sm-static-rp-configurations/
A company is implementing 802.1X authentication. These are the requirements:
Employees who pass 802.1X authentication should be placed VLAN 3.
Guests and employees who cannot authenticate, or fail authentication, should be placed in VLAN4.
Different users might connect to port at different times, but only one device will connect to the port at the same time.
802.1X is enabled Globally on the switch (aaa port-access authenticator)
Which settings correctly configure the HP ProVision edge ports?
Sets the period during which the port does not try to acquire a supplicant. The period begins after the last attempt authorized by the max-requests parameter fails (next page). (Default: 60 seconds)
ftp://ftp.hp.com/pub/networking/software/Security-Oct2005-59906024-Chap08-PortAccess(8021x).pdf
Refer to the exhibit.
Switch 1 and Switch 2 have established and Interswitch Connection (ISC) and two distributed trunks. All of the switches have Multiple Spanning tree Protocol (MSTP) enabled. Where does Switch 1 transmit or process Bridge Protocol Data Units (BPDUs)?
http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c03015912-2.pdf
- Select Question Types you want
- Set your Desired Pass Percentage
- Allocate Time (Hours : Minutes)
- Create Multiple Practice tests with Limited Questions
- Customer Support
Currently there are no comments in this discussion, be the first to comment!