Cyber Monday 2024! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25

- Free Preparation Discussions

Juniper Exam JN0-351 Topic 5 Question 18 Discussion

Actual exam question for Juniper's JN0-351 exam

Question #: 18
Topic #: 5

[All JN0-351 Questions]

Which statement is correct about the storm control feature?

AThe storm control feature is enabled in the factory-default configuration on EX Series switches.

BThe storm control feature requires a special license on EX Series switches.

CThe storm control feature is not supported on aggregate Ethernet interfaces.

DThe storm control configuration only applies to traffic being sent between the forwarding and control plane.

Show Suggested Answer

Suggested Answer: A

Option A is correct.The storm control feature is enabled in the factory-default configuration on EX Series switches12.On EX2200, EX3200, EX3300, EX4200, and EX6200 switches, the factory default configuration enables storm control for broadcast and unknown unicast traffic on all switch interfaces2.On EX4300 switches, the factory default configuration enables storm control on all Layer 2 switch interfaces1.

Option B is incorrect.The storm control feature does not require a special license on EX Series switches34.

Option C is incorrect. There's no information available that suggests the storm control feature is not supported on aggregate Ethernet interfaces.

Option D is incorrect.The storm control configuration applies to traffic at the ingress of an interface5, not just between the forwarding and control plane.

by Rickie at May 08, 2024, 02:33 PM

Limited Time Offer

25%

Off

Get Premium JN0-351 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Makeda

6 months ago

I guess we’ll find out soon. These questions can be tough!

upvoted 0 times

...

Talia

6 months ago

I went with A, thinking it's enabled by default.

upvoted 0 times

...

Fredric

7 months ago

I chose that too. Answer C, right?

upvoted 0 times

...

Augustine

7 months ago

Yeah, that was confusing. I think it's not supported on aggregate Ethernet interfaces.

upvoted 0 times

...

Makeda

7 months ago

I did. I wasn't sure about the factory-default settings.

upvoted 0 times

...

Talia

7 months ago

Did anyone find that storm control question tricky?

upvoted 0 times

...

az-700 pass4success az-104 200-301 200-201 cissp 350-401 350-201 350-501 350-601 350-801 350-901 az-720 az-305 pl-300

Warning: Cannot modify header information - headers already sent by (output started at /pass.php:70) in /pass.php on line 77