Oracle Exam 1Z0-580 Topic 6 Question 21 Discussion

Actual exam question for Oracle's 1Z0-580 exam

Question #: 21
Topic #: 6

You are performing an initial AI Installation of Oracle Solaris 11. You have not identified a target disk for the root pool and your installation fails. What are the two possible disk based reasons for this failure?

AYou need to specify the dump and swap partitions in the AI manifest to perform a successful Oracle Solaris 11 Installation.

BThe disk does not have an SMI label.

CYou have not specified a mirrored dataset for the root pool.

DThe disk or slice does not match or meet the recommended size parameters of approximately 13 GB.

EZFS requires the disk to be partitioned first and the root partition must be active.

Show Suggested Answer

Suggested Answer: B, D

B: The disk intended for the root pool must have an SMI label. Otherwise, the installation will fail.

D: The default target location for the installation is the first disk found on each client that meets the size requirement. If the size of a disk is greater than or equal to the recommended size, the installer selects that disk as the installation target. If the size of the disk is less than the recommended size, the installer checks the next disk. If no disk is found that meets the size requirement, the automated installation fails for that client.

Note:

* If you do not specify a target location on a client for installing the Oracle Solaris OS, AI selects a default target.

Incorrect:

not A: <swap> and <dump> -- Optional. You can use AI to configure swap and dump during the automated install.

Not C: A mirrored dataset for the root pool is not required.

by Sheridan at May 03, 2022, 08:42 AM

Limited Time Offer

25%

Off

Get Premium 1Z0-580 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!